GENERAL BOATING WATERSPORTS & BOATS SEATING COVERS/TOPS MAINTENANCE ELECTRICAL HARDWARE PLUMBING PROPS & ANODES FUEL ELECTRONICS & NAVIGATION SAFETY TROLLING & FISHING ANCHORING/ MOORING TRAILERING PAINT VENTILATION FASTENERS STEERING ENGINE ITEMS ARE STOCKED IN OUR WAREHOUSES BASED ON REGIONAL DEMAND. IF AN ITEM IS NOT IN STOCK AT A LOCAL WAREHOUSE, ADDITIONAL CHARGES MAY APPLY. u - WARNING Cancer Causing See www.P65Warnings.ca.gov v - WARNING Reproductive Harm w - WARNING Cancer and Reproductive Harm 1056 SECTION ELECTRICAL Switched Solenoid Item# Volts Rating Replaces List 969-1002203c 12 65A CH 24059-08 48.99 EA 969-1002204c 12 85A CH 24059 42.49 EA Remotely switch high amperage loads with a low amperage on-off switch. • Copper #10-32 ignition and ground terminals • Copper 5/ 16"-24 contact terminals • Plated steel case, copper contacts • Hex nuts and washers included • Bracket mounting holes 5/ 16" x 19/ 32", 213/ 64" on centers • UL and CE approved CONTINUOUS DUTY SOLENOID Remotely switch high amperage loads with a low amperage on-off switch. • Intermittent rating 100A: 10 seconds • Copper #10-32 signal terminals • PVC coated steel case • Copper 5/ 16"-24 contact terminals • Bracket mounting holes 5/ 16" x 19/ 32", 2 13/ 64" on centers • UL and CE approved PVC COATED CONTINUOUS DUTY SOLENOID Item# Volts Rating Replaces List 969-1002205c 12 85A CH 24117-01 57.29 EA Item# Volts Replaces List 969-1002206c 6-12 CH M-200 37.19 EA Intermittent switching of high amperage loads with a low amperage on-off switch. • #10/32 signal terminals • Signal voltage 12V DC and contact voltage 6-12V DC • Copper 5/ 16"-24 contact terminals • Bracket mounting holes 5/ 16" x 19/ 32", 2 13/ 64" on center • Rated at 750A make/100A break, this solenoid is for intermittent use only: 10 seconds ON, 20 minutes OFF (ideal for engine cranking) INTERMITTENT DUTY SOLENOID Item# Volts Rating Replaces List 969-1002201c 12 75A CH 24450 84.19 EA Two solenoids in one saves money and simplifies wiring. Provides braking dynamic capability for permanent magnet motors when coils are not energized. • Rated at 75A make and break at 12V • DPDT intermittent duty • Comparable to Cole Hersee #24450 MOTOR REVERSING SOLENOID Intermittent duty solenoid. Insulated, with plated steel housing. Normally Open contacts, one circuit: Off/On. 750A make, 100A break, 10sec on 20 min off. Item# List 12-24047BXc(LK) 69.49 EA Continuous duty solenoid. Insulated, with steel housing. Normally open contacts, one circuit: Off/On. 85A continuous. Item# Volts Amps Qty List 12-24059BPc 12 85 Retail 76.59 EA Marine construction. Plated steel case with added plastic coating. Insulated SPST, normally open. One circuit: Off/On. Bracket mounting holes 5/ 16" x 19/ 32" on 213/ 64" centers. Copper contacts and platicized steel housing. Continuous duty: 65A at 12V DC. Intermittent duty 750A make, 100A break. 10 sec. on, 30 min. off. Item# List 12-2411701BPc(LK) 108.39 EA Insulated. SPST, normally open. One circuit: Off/On. Continuous duty: 65A at 12V DC. Bracket mounting holes 5/ 16" x 19/ 32" on 213/ 64" centers. Copper contacts. Copper terminals 10-32 thread and 5/ 16"-24 thread. Hex nuts and lock washers included Item# Volts List 12-2405908BPc 12 103.09 EA • Insulated. Plated steel housing. • SPST. Continuous rating: 85A. Maximum Current, Make 120A/ Break, 65A • Copper terminals • 10-32 thread and 5/ 16"-24 thread. Hex nuts and lock washers included Item# Volts Amps List 12-24063BXc(LK) 24 85A 79.49 EA Item# List 12-24450BXc(LK) 200.09 EA CONTINUOUS DUTY SOLENOID DPDT intermittent duty. Common ground coil. Two blade coil terminals, 5/ 16" -24 large studs. Copper contacts. F bracket. 75A make and break, maximum On time 5 mins. 125A make and break, maximum On time 0.5 sec. Allow 5 mins. Off after max. On time. Max. operating voltage 14.5V DC. Cycle life 10,000 cycles at 5 sec. On, 25 sec. Off. Shipped w/ mounting hardware. 12V MOTOR REVERSING SOLENOID 12V SPST SOLENOID CONTINUOUS DUTY SOLENOID, 24V 12V SOLENOID INSULATED CONTINUOUS DUTY SOLENOID
RkJQdWJsaXNoZXIy MTI2MTky