ITEMS ARE STOCKED IN OUR WAREHOUSES BASED ON REGIONAL DEMAND. IF AN ITEM IS NOT IN STOCK AT A LOCAL WAREHOUSE, ADDITIONAL CHARGES MAY APPLY. u - WARNING Cancer Causing See www.P65Warnings.ca.gov v - WARNING Reproductive Harm w - WARNING Cancer and Reproductive Harm AWNINGS & ACCESSORIES CAMPSITE LIVING GENERAL ACCESSORIES ROOFING & SEALANTS SANITATION HEATING & COOLING GRILLING & CAMPWARE HOUSEWARES CLEANERS & WAXES FRESH WATER APPLIANCES GENERATOR & POWER SOLUTIONS LIGHTING HARDWARE SERVICE & MAINTENANCE STEPS & TIEDOWNS TOWING & HITCHES ELECTRICAL ELECTRONICS VENTS CARRIERS & COVERS JACKS & LEVELERS LP GAS 484 LIGHTING Item# Description Volts Amps Bulb Case 50-52891c Amber 12.8V .054A LED 12 • Meets the requirements of SAE/DOT/FMVSS/CMVSS standards when properly installed • Stud mount black base; two-wire design • Lens with reflex eliminates need for separate reflector • 6 diodes • Installation hardware included • Acrylic lens, ABS housing • Size: 2.875" x 2.125" x .938" LED SQUARE STUD-MOUNT CLEARANCE/MARKER LIGHT Item# 177-V547c For all trailers over 80" wide. Kit provides all rear legal lighting and reflectors for trailers over 80" wide. Includes one each low profile 456/456L tail light, 25' trailer harness, 48" trunk connector, license bracket, mounting hardware and installation instructions. OVER 80" SUBMERSIBLE REAR LIGHT KIT Item# Description 177-V947c LED Trailer Light Kit • Submersible rear lighting kit for all trailers 80" wide and over • Includes 856/856L LED tail lights plus license bracket, mounting hardware and Installation instructions • Replacement harness available separately • Provides rear lighting and reflectors, front clearance/side marker lights, front side reflectors and rear identification lights (necessary to meet all DOT requirements) LED OVER 80" REAR LIGHTING KIT Item# Description 177-E456c Curbside/ Without License Light 177-E456Lc Roadside/ With License Light Low profile. Includes the following functions: stop, turn, tail, rear clearance, rear reflex, side marker, side reflex and license light. Housing slides out for easy maintenance and bulb replacement while maintaining gasket seal. Grounds through separate lead wire. Mounts on slide-on 2" centers and includes mounting hardware. OVER 80" SUBMERSIBLE COMBINATION TAIL LIGHT • Combination stop, turn and tail light • Super bright LED optics-no bulbs to break or burn out • 100,000-hour-rated life • Fully sealed, submersible construction • Potted circuitry protects against moisture, corrosion and vibration • Lower amp draw than incandescent • Designed to directly replace 456-series incandescent lights • Integral, dedicated side marker diode • Exceeds all DOT rear lighting and rear lighting and reflex requirements for trailers 80" wide and over LED STOP AND TAIL LIGHT V856 V856L Item# Description Case 177-V856c w/o License Light 6 177-V856Lc w/License Light 6 Item# Description Volts Amps Bulb Case 50-52591c Amber module only 12.8V .2A Incandescent 12 50-52601c Red module only 12.8V .2A Incandescent 12 • Meets the requirements of SAE/DOT/ FMVSS/CMVSS standards when properly installed • Sonically sealed • Waterproof • PC-rated design • Designed for 12V systems • Available in amber or red Sonically sealed, waterproof marker/clearance replacement light. SEALED MARKER/CLEARANCE REPLACEMENT LIGHTS 52591 52601 Item# Lens Volts Amps Bulb Case 50-52521c Amber 12.8V .2A Incandescent 12 50-52531c Red 12.8V .2A Incandescent 12 • Meets the requirements of SAE/DOT/ FMVSS/CMVSS standards when properly installed • Sonically sealed, waterproof • Stud-Mount • Polycarbonate lens and housing, stainless steel base • Single wire design grounds through mounting hardware • Size: 2.063" x .688" x 1" SEALED MARKER/CLEARANCE LIGHT 52521 52531 Item# Description Size Volts Amps Bulb Case 50-52851c Amber 2.5" x 1.25" x 1" 12.8V .023A LED 12 50-52861c Red 2.5" x 1.25" x 1" 12.8V .023A LED 12 • Meets the requirements of SAE/DOT/ FMVSS/CMVSS standards when properly installed • Sonically sealed, waterproof • Accepts standard 1 or 2-wire plugs • Single wire design grounds through mounting hardware • Black base • Mounting hardware included • Single diode • Polycarbonate lens and housing LED MINI SEALED MARKER/CLEARANCE LIGHTS 52851 52861 Item# Lens Volts Amps Bulb Case 50-52561c Amber 12.8V .051A LED 12 50-52691c Red 12.8V .051A LED 12 • Meets the requirements of SAE/DOT/ FMVSS/CMVSS standards when properly installed • Sonically sealed, waterproof • Polycarbonate lens and housing, plated steel stud • Single wire design grounds through mounting hardware (6" Lead) • Size: 2.125" x 1.125" x 1.063" LED SEALED STUD MOUNT SIDE MARKER/CLEARANCE LIGHT 52561 52691 Item# Description Size Volts Amps Bulb Case 50-52871c Amber 2.5" x 1.063" x 0.688" 12.8V .046A LED 12 50-52881c Red 2.5" x 1.063" x 0.688" 12.8V .046A LED 12 • Meets the requirements of SAE/DOT/ FMVSS/CMVSS standards when properly installed • Sonically sealed, waterproof • Surface mount installation • Accepts standard 2-wire plugs • Chrome trim ring base and mounting hardware included • Two diode • Polycarbonate lens and housing LED MINI SEALED CLEARANCE/MARKER LIGHTS 52871 52881
RkJQdWJsaXNoZXIy MTI2MTky