GENERAL BOATING WATERSPORTS & bOATS SEATING COVERS/TOPS MAINTENANCE ELECTRICAL HARDWARE PLUMBING PROPS & aNODES FUEL ELECTRONICS & NAVIGATION SAFETY TROLLING & fISHING ANCHORING/ mOORING TRAILERING PAINT VENTILATION FASTENERS STEERING ENGINE Items are stocked in our warehouses based on regional demand. If an item is not in stock at a local warehouse, additional charges may apply. u - WARNING Cancer Causing See www.P65Warnings.ca.gov v - WARNING Reproductive Harm w - WARNING Cancer and Reproductive Harm ELECTRONICS 12 Item# 322-0101267615w Position your Panoptix LiveScope™ LVS32 transducer on this 0° pole mount for an optimal viewing angle while ice fishing (works for open water fishing too). 0 DEGREE LIVESCOPE POLE MOUNT Item# 322-0101267640w Connect your Panoptix™ LiveScope System or Panoptix PS22 transducer and compatible ECHOMAP chartplotter to the battery of your compatible Panoptix ice fishing bundle with this power cable. It also includes a convenient charge port plug and 10A fuse holder. Compatible with the Panoptix™ LiveScope Ice Fishing Bundle. PANOPTIX™ POWER CABLE Item# 322-0101240600w Reduces excessive water spray from your compatible transducer when your boat is running at high speeds. TRANSDUCER SPRAY SHIELD Item# 322-0101244533w Connect a Garmin GT30 transom mount scanning transducer and a Garmin GT8HWIH, GT15M-IH, Airmar P72 or Airmar P79 in-hull mount traditional transducer to a compatible ECHOMAP Plus™, echoMAP CHIRP chartplotter/sonar combo or a GPSMAP 10X2xsv/12X2xsv chartplotter. This adapter cable allows the above units to continue to display water depth from the in-hull transducer in instances when the transom mount transducer loses depth reading due to cavitation. TRANSDUCER Y CABLE Item# Length Type 322-0101161732w 10' 12-pin 322-0101161742w 30' 12-pin Extend the length of your compatible 12-pin transducer with these cables. Supports 12-pin Airmar transducers with XID. SCANNING TRANSDUCER EXTENSION CABLE Item# Length Type 322-0101161710w 10' 4-pin 322-0101161750w 10' 8-pin Extend the cable length of your compatible transducer. TRANSDUCER EXTENSION CABLE Item# 322-0101161300w This adapter allows you to connect the wires on legacy 6-pin transducers with newer sonar that require a 8-pin connection. TRANSDUCER ADAPTER WIRE BLOCK Item# 322-0101161310w Connect a compatible bare wire transducer to a Garmin 12-pin sounder connector with this wire block adapter. BARE WIRE TRANSDUCER TO 12-PIN SOUNDER WIRE BLOCK ADAPTER Item# Type 322-0101271900w 4-pin 322-0101161200w 6-pin This adapter allows you to connect newer 8-pin transducers. TRANSDUCER ADAPTER CABLE Item# 322-0101212210w Use this adapter cable to connect an 8-pin transducer with XID to a 12-pin sonar port on a compatible device. TRANSDUCER ADAPTER CABLE W/XID Item# Description Fits 322-0101244001w Flush Mt. STRIKER™ 5cv, dv, sv 322-0101244002w Flush Mt. STRIKER™ 7cv, dv, sv Easily position your compatible device against most flat surfaces in your boat with this flush mount kit. It includes hardware, instructions and a template for sleek installation. GARMIN FLUSH MOUNT KIT 0101244001/02 Item# 322-0101267610w This pole mount allows you to rotate your Panoptix PS22-TR LiveVü Forward and Down transducer, while under the ice, to locate fish around you. The mount can go to about 4.25' (maximum depth) below the surface. PANOPTIX ICE FISHING POLE MOUNT
RkJQdWJsaXNoZXIy MTI2MTky